How To Sheathe A Metal Door

Table of contents:

How To Sheathe A Metal Door
How To Sheathe A Metal Door
Anonim

Over time, the entrance doors cease to delight with their unique beauty and need to be repaired. It is not very difficult to knock off the front door. However, this case requires special attention.

How to sheathe a metal door
How to sheathe a metal door

Instructions

Step 1

Front door upholstery is most often done from the outside. If desired, you can also make the interior upholstery. First you need to pick up the material. Leatherette is very popular. Sometimes the upholstery is done with an oilcloth on a cloth basis. Don't forget about soundproofing. For this purpose, plastic batting, foam rubber or other filler that is capable of retaining sound can be used. If there is no way to get good material, then use regular crumpled newsprint. Also for work you will need furniture nails that have a decorative cap. You can use a decorative string or a copper cable for upholstery.

Step 2

Remove the door from its hinges and position it horizontally. You can put it on wooden chairs, stools, etc. Also remove all protruding parts. Now proceed to cutting the leatherette. Cut out the main panel. Be sure to allow a 5 cm allowance on all sides. Remember to cut holes for the handle and lock.

Step 3

Prepare three roller strips from the same material. Glue these strips one by one to the door. Then put cotton wool or foam rubber on them, the thickness of which should not exceed three centimeters. Roll the leatherette so that rollers are formed. Glue the second edge of the strip to the door as well. The roller should be slightly overhang to tightly close the gap between the door and the frame.

Step 4

Next, spread the batting or foam rubber on the door and cover it with leatherette. Tuck the leatherette under the foam and secure with glue. This creates another bead. Then you can punch a pattern on the doors. You can stretch a cable or decorative thread between the studs. This will give the door a more visual impact. This piercing will hold the insulation well and will not let it slide over time. Also, when upholstering, you can put curly washers under the door caps. You can use your imagination to decorate the front door.

Step 5

Now you can proceed to the installation of the removed parts. Next, you can install the door in its place. Adjust it if necessary.

Recommended: