How To Mount Polypropylene Pipes

Table of contents:

How To Mount Polypropylene Pipes
How To Mount Polypropylene Pipes

Video: How To Mount Polypropylene Pipes

Video: How To Mount Polypropylene Pipes
Video: How to joint Polypropylene Pipe - PPR plastic pipes. Polyfusion welding 2024, March
Anonim

Polypropylene pipes make it possible to create heating and water supply systems without the help of professional welders, without the use of expensive materials and equipment. All that is needed for the installation of polypropylene pipes is a special welding machine and the ability to use it.

How to mount polypropylene pipes
How to mount polypropylene pipes

Necessary

Stripping for reinforced pipes, pipe cutter, electric welding machine for polyphase welding, contact thermometer, tape measure, marker, rags, alcohol,

Instructions

Step 1

Prepare pipes and fittings. Before starting the installation of polypropylene pipes, cut them to size. You need to measure the distances with a tape measure and make notes with a marker. For cutting, special scissors are used, which allow you to cut the pipe evenly and effortlessly. Pipe sections and fittings for their connection should not have chips and cracks, therefore, before starting installation, you must carefully inspect all prepared parts. The edges of the pipe must be thoroughly cleaned of debris and degreased with rags and alcohol.

If the pipes are reinforced, remove the foil layer from them for the length of the section that is necessary for welding. This is done using a special stripping.

Step 2

Thoroughly clean the surface of the welding machine nozzles by wiping them with a cloth soaked in alcohol. Attach the nozzles of the size you need to the welding machine, set the temperature on it from 200 to 270 degrees Celsius. Plug in the device and wait for it to warm up, the heating time depends on the ambient temperature. Measure the temperature of the device with a contact thermometer, if it reaches 260 degrees Celsius, you can start working.

Step 3

In one hand we take the fitting that you will now connect to the pipe, in the other hand take the pipe itself. We insert the pipe inside the nozzle on the welding machine, and put the fitting on the coupling part. Rotating both parts with little effort, we bring them closer to the center - so that they go deep into the nozzle completely. After that, we leave them in this position for 2 - 3 seconds, so that their surfaces are warmed up. After that, remove the pipe and fitting from the nozzle and immediately insert the pipe into the fitting. The material will set quickly, so remember to center the parts right away as you like. You cannot hesitate, otherwise the connection may turn out to be uneven or not sealed.

Step 4

We fix the mounted element to a permanent place and proceed to the further installation of the system.

Recommended: