How To Drill A Hole In Wood Without A Drill

Table of contents:

How To Drill A Hole In Wood Without A Drill
How To Drill A Hole In Wood Without A Drill

Video: How To Drill A Hole In Wood Without A Drill

Video: How To Drill A Hole In Wood Without A Drill
Video: How To Drill A Straight Hole Without A Drill Press 2024, March
Anonim

To cut out the elements of the internal ornament, you need to make a hole in the part and thread a saw blade through it. If you don't have a special drill at hand, there are several other ways.

Hole in wood
Hole in wood

The easiest way to get these holes is to use an awl with a diameter of 1 to 3 mm. It is easy to make an awl from a thick needle or even from a trim of piano wire, the length of which is about 5 cm. The needle or wire is first driven into a piece of hardwood half the length, and a handle is subsequently made from this tree. The end of the wire remaining outside is sharpened on 3 or 4 edges. A well-made awl acts as a drill in this case, piercing the wood, it is rotated and it cuts and twists the wood fibers, and does not just push them apart.

DIY drill

The best suited for this operation are small hand drills, the likeness of which you can make yourself. To do this, two laces and a handle are tied from above to a rigid axis, which can be a steel or wooden rod, and a sharpened nail from below. In the middle of the rod, you need to fix a heavy flywheel, which will act as an inertial battery. In order to put this drill into action, the laces are manually wound on the rod, and then, having set the nail in the right place, they press the handle. The rod rotates and the nail drills, the pressure on the handle is stopped when the laces are completely unwound. The flywheel rotates by inertia and again winds them onto the rod, and then stops and you need to press the handle again. Tough woods may not succumb to such a drill, as the drill will get stuck and slow down the rotation.

DIY screw drill

For the construction of a screw drill, a rotation mechanism from a children's top is well suited. Instead of a cartridge, a compass pencil holder works well. When lowering the engine with the same thread by hand, the screw axis of the drill begins to rotate. With this mechanism of action, the drill head must necessarily rotate on the axis freely.

If the top is not at hand, the screw of this action can be bent by yourself. To do this, you need a strip of steel, one end of which must be fixed in a vice fixed on a machine or on a table, and the other end must be fixed in a hand vice. When the hand vise rotates, the strip will evenly twist into a screw, on which a wooden slider with a pre-drilled hole is then mounted. In order for the engine not to have any difficulties when passing the helical surface of the strip, the strip is heated and, passing through it with the engine in this state, a thread is made on the strip. For making a hat, a small wooden ball is suitable, in which a hole is made in diameter slightly larger than the diameter of the screw.

Recommended: