How To Install Roller Shutters

Table of contents:

How To Install Roller Shutters
How To Install Roller Shutters

Video: How To Install Roller Shutters

Video: How To Install Roller Shutters
Video: How Roller Shutters are installed 2024, March
Anonim

Roller shutters, or metal shutters, are a special metal structure that protects windows and doors. The protective sheet, consisting of stainless aluminum profiles, lamellas, rises and falls vertically, twisting into a roll. The lamellas, in turn, are fastened with special locks, which gives the structure rigidity and integrity.

How to install roller shutters
How to install roller shutters

Instructions

Step 1

Roller shutters consist of:

- a box in which the roller for winding the web is located. The box is installed on top of a door or window opening;

- the canvas itself from fastened lamellas;

- lateral guides for the movement of the web;

- drives and control devices.

Step 2

Rollers come with an overhead box and a built-in one. Roller shutters with a built-in box are usually installed during the construction phase. They do not change the appearance of the building and are combined with any style of decoration. Roller shutters with an overhead box can be installed at any time, in any opening.

Step 3

For proper installation of roller shutters, you must carefully prepare the opening of the window or door. The opening must be even and smooth, without plaster sagging and cracks. The measurement of the opening should be as accurate as possible. The roller shutter guides are fixed vertically in the opening, the box - horizontally above the opening or in the opening.

Step 4

First of all, unpack the roller shutters, check if the package is correct.

Mark and drill holes in the guide rails for fastening in 4, 5-5 cm increments. The outermost holes should be at a distance of 10-15cm from the tire edges.

Step 5

Mark and drill holes in the side and rear surfaces of the box cover to install it.

Drill a hole in the back of the duct cover for the power cord.

Step 6

Assemble the roller shutter frame, box and guide rails. Install the two guides in the cover.

Reinforce the frame at the installation site. The guide rails must be strictly vertical, the box must be installed horizontally, and the whole structure must be symmetrical about the opening. Check the correct installation against the building level.

Drill a hole in the wall for the outlet of the electrical cord, install a protective spring or tube in the place of the outlet.

Step 7

Assemble the roller shutter motor according to the instructions, thread the motor cable into the drilled hole.

Install and secure the electrical switch and actuator controls at the site of use.

Step 8

Place the roller shutter curtain in the guide rails. Wrap the shaft in the box with a soft material to avoid damaging the blade. Insert the blade into the box above the shaft from the side of the rear panel.

Wind the traction element onto the shaft. Assemble the blade together with the traction element.

Step 9

Install stoppers that regulate the height of the lifting of the blade.

Check the new roller shutters, adjust them.

Replace the box cover. Close all technological openings with decorative plugs.

Recommended: