How To Polish Wood

Table of contents:

How To Polish Wood
How To Polish Wood

Video: How To Polish Wood

Video: How To Polish Wood
Video: How to Polish Wood | Woodworking 2024, March
Anonim

Sometimes, when caring for old furniture or restoring it, you cannot do without applying a new polish. Polishing is a rather laborious operation. First, try polishing a few unnecessary pieces of plywood. With practice, you will achieve a positive result.

How to polish wood
How to polish wood

Necessary

  • tampon,
  • varnish,
  • alcohol,
  • linseed oil.

Instructions

Step 1

The surface prepared for polishing should not have cracks, gaps, knots. Pre-sand it with a coarse sandpaper, and then with a finer one.

Step 2

For wood polishing, an alkaline polish is used, the film of which is lightfast and elastic. This polish is scratch resistant and has good polishing properties.

Step 3

The first stage of polishing is priming, i.e. applying a thick polish to a wooden surface that is not diluted with alcohol. For dense and hard types of wood, it is required to dilute the polish with alcohol. Primer and polish strokes should cover each other.

Step 4

After priming, leave the part to dry in a room with a temperature not lower than + 20 °. Make sure there is no dust. Place the primed surface on the floor. Drying time is three days. Then sand with sandpaper or pumice powder.

Step 5

After priming, carry out the first and second liquid polish. The polishing speed should be faster than with priming. Dry the part for 2 days after the first polishing. After the second polishing - 4 days. For the third, final polish, apply an even thinner polish at a quick pace.

Step 6

To polish wood, take a large piece of cotton wool and wrinkle it tightly in your hands. On one side, dampen it with a few drops of polish. Wrap in woolen cloth and wrap the resulting swab in a clean linen cloth. Linen fabric will not leave fine fibers on the surface of the wood.

Step 7

Pour a well-filtered polish into the middle of the resulting swab and make a test smear (las) on any auxiliary surface.

Step 8

If you poured the correct amount of polish the smear will leave an instantly drying mark. A not immediately drying and bubbling mark is a sign of excess polish. Wipe off excess polish from the swab by rubbing on an auxiliary surface.

Step 9

When using the polish from the tampon, increase the pressure on it. And when the las is no longer noticeable, add polish to the tampon.

Step 10

Be careful not to dry the polish on the edges of the tampon, otherwise it may scratch the surface. Remove dried polish with alcohol.

Step 11

At each stage of polishing, lift the swab off the surface with a sliding motion from the very edge of the surface to be polished. This will help prevent excess polish stains.

Step 12

If braking occurs in the movement of the tampon, apply three drops of linseed oil to the work surface. After the parts dry, remove the oil from the polish with ethyl alcohol. The coating film is not only leveled, but also degreased. Perform this operation with a clean swab.

Recommended: