How To Make A Cascade

Table of contents:

How To Make A Cascade
How To Make A Cascade

Video: How To Make A Cascade

Video: How To Make A Cascade
Video: Creating a Cascade Drape 2024, March
Anonim

A cascade is a complex of several reservoirs at different levels. Water flows from one reservoir to another, imitating a waterfall or a stormy stream with rapids. The cascade is able to decorate any suburban area. You can arrange it yourself.

How to make a cascade
How to make a cascade

It is necessary

Shovel, pump with hoses, butyl rubber film, stones

Instructions

Step 1

First of all, you need to choose and mark the place for the cascade. Then you should dig several independent pits for the ponds. Each must be on a level lower than the previous one. Then you need to cover the bottom of the pits with butyl rubber film. The film should be laid in such a way that the one located in the upper pit overlaps the edge of the one in the lower pit. This is to prevent the pond from leaking. The film must be masked with natural stones and pebbles. Can be built from a large flat stone and several small small waterfalls.

How to make a cascade
How to make a cascade

Step 2

Now we need to ensure that the ode in the cascade falls down vertically and resembles a wall. To do this, place a large flat stone across the entire width of the channel. It should hang slightly over the lower pond. If the rock is not wide enough and water can go around it, there will be no waterfall. But you can arrange not a waterfall, but just a rock sill. Then you should put several pebbles of various shapes in the path of the water. The water flow will bend around them and break into several parts.

How to make a cascade
How to make a cascade

Step 3

Do not forget to make sure that the water flows into your cascade without interruption. This requires a pump. It needs to be powerful enough to fit your body of water. Before purchasing a pump, it is better to first calculate how much power is needed. The throughput of the pump should be one and a half times the volume of the cascade. That is, if the pond, for example, is 1000 liters in volume, it will need a pump with a throughput of 1500 liters per hour.

When a suitable pump is purchased, it can be installed. Water must be taken from the lower reservoir and pumped into the upper one. The upper reservoir should be the smallest and the lower one the largest. Remember to mask the hoses or bury them in the ground for a natural cascade.

Recommended: