We Paint A PVC Window

Table of contents:

We Paint A PVC Window
We Paint A PVC Window

Video: We Paint A PVC Window

Video: We Paint A PVC Window
Video: Как красить окна и двери из ПВХ 2024, March
Anonim

Painting plastic windows at the customer's address is a complex and time-consuming process, which is best entrusted to professionals.

Painted plastic window
Painted plastic window

It is necessary

  • 1. Two-component polyurethane paint for pvc.
  • 2. Compressor.
  • 3. Spray gun.
  • 4. Masking polyethylene film.
  • 5. Masking tape.
  • 6. Insulating tape.
  • 7. Solvent 646.

Instructions

Step 1

Before starting work, remove the protective film from the PVC profile on the window. We wipe the window with a cleaner designed to degrease the plastic surface - this is the first rough cleaning. In its absence, you can use the composition "Cosmofen".

We glue the sealing gum of the glazing bead and frames with shutters with electrical tape. We glue the double-glazed window with masking tape along the contour, and inside we glue a polyethylene film. All unpainted parts of the window profile are also covered with masking tape.

Then we cover all the walls, ceiling, floor and furniture with camouflage film so as not to stain them.

Image
Image

Step 2

We connect the compressor to electricity, pour paint into the spray gun through a thin 180 micron mesh filter, set the pressure on the compressor pressure gauge to 2.5 atmospheres.

Before painting, we wipe the window profile again with a cleaner, let it dry for 7 minutes and start painting. A layer of paint must be applied with a thickness of 80 µm. If the layer is thicker, the paint will dry for more than 10 minutes, and dust from the air will have time to settle on the surface to be painted. If the layer is much thinner, the paint will not adhere to the window. With a layer thickness of 80 microns, the paint will dry in 5 minutes, but the window cannot be closed yet. You will have to wait until all the thinner has evaporated from the paint, about two hours, and only after that you can close the window. But immediately after painting it is necessary to wash the spray gun, otherwise it will be very difficult to wash it later.

Image
Image

Step 3

At the end of the work, after two hours, all masking material must be removed. The most important thing in this work is the means of protection. The solvent has a very pungent odor, therefore it is necessary to work in a chemical respirator.

Recommended: