How To Remove A Sticker

Table of contents:

How To Remove A Sticker
How To Remove A Sticker

Video: How To Remove A Sticker

Video: How To Remove A Sticker
Video: Goo Gone vs WD 40 Adhesive Sticker Remover!!! (How to Remove Stickers From Wood) 2024, March
Anonim

New plastic windows often have stickers to protect them from scratches during transportation. After installing the windows, stickers become unnecessary, moreover, they spoil the appearance of the room. There are several ways to get rid of them.

How to remove a sticker
How to remove a sticker

It is necessary

  • - peanut butter;
  • - liquid for washing glasses;
  • - putty knife;
  • - alcohol, gasoline, white spirit, acetone;
  • - hairdryer;
  • - special cleaner;
  • - rags.

Instructions

Step 1

If the windows were installed less than a month ago, then the process of cleaning them from the protective film will take a minimum of time. Simply grab the end of the duct tape with your fingernail and pull. The tape will come off easily without leaving any traces of glue on the plastic.

Step 2

If for some reason you could not remove the film from the windows in time, then use peanut butter to facilitate the process. Apply oil to decals. Wait 10-15 minutes. Using a wide spatula, carefully remove the film from the windows. Instead of pure peanut butter, you can use any product or cream that contains peanut butter. In this case, Peanut oil should be listed among the other ingredients. Food products or cosmetic creams should be kept longer (30 minutes). the concentration of oil in them is less.

Step 3

Spray glass cleaner on the decals. After a few minutes, clean the plastic with a spatula, plastic or wooden ruler. Remove glue residues on the profile with nail polish remover, acetone, white spirit or gasoline. First, test these fluids in an inconspicuous area. they can cause haze and haze in some plastics.

Step 4

Take a hair dryer to dry your hair. Turn on to maximum power and direct the air stream to a small area of the sticker. When the heat melts the adhesive, peel off the protective film as much as you can. Warm up the rest of the area gradually and clean in the same way. If you don't have a hair dryer, try cleaning your windows on a hot summer day. The glue under the film will heat up in the sun. And after removal, you can remove its remnants with ordinary alcohol.

Step 5

Purchase a special cleaner such as COSMOFEEN from a hardware store or a plastic window manufacturer. The number in the name of the purifier (5, 10 or 20) indicates the concentration of active substances in the solution. Apply the solution to the decal and then clean the plastic with a spatula. Then walk the profile again with a rag moistened with cleaner. Due to the fact that it dissolves the top layer of plastic, minor scratches on the profile will disappear and the window will look like new.

Recommended: