How To Mount The Dryer

Table of contents:

How To Mount The Dryer
How To Mount The Dryer

Video: How To Mount The Dryer

Video: How To Mount The Dryer
Video: Tumble Clothes Drier (Dryer) Wall Mount | How to DIY 2024, March
Anonim

Gone are the days when linen was dried on ropes stretched between nails hammered. It is much more convenient to use ready-made metal floor or hanging dryers, which allow you to compactly hang wet laundry in the most unclaimed places of the apartment - in the corners or under the ceiling.

How to mount the dryer
How to mount the dryer

It is necessary

  • - Dryer;
  • - drill;
  • - plastic or wooden plugs;
  • - screwdriver or screwdriver.

Instructions

Step 1

Prepare a place to mount the dryer, analyze the ceiling and walls. If there are voids under the outer thin wall or plaster is crumbling in pieces, find a safer place, since under the weight of damp linen, the entire structure may simply collapse. The best surface for attaching the dryer is concrete or sturdy wooden beams.

Mounting scheme
Mounting scheme

Step 2

Mark the ceiling and wall according to the dimensions of the dryer and the desired location. Carefully check the perpendicularity to the walls and the alignment of the brackets and brackets at the same level. Check again if the laundry will interfere with opening and closing the doors and free passage. Do not install dryers in rooms where people smoke often, as the laundry will constantly smell of smoke.

Step 3

Take brackets with rollers and use screws to secure to the ceiling. Pre-drill a larger hole in the concrete wall, then hammer plastic or wooden plugs into it with a hammer. Attach the bracket and use a screwdriver to tighten the screws (they should come with the dryer).

Step 4

At a height of 1, 2-1, 5 meters from the floor on the wall, fix the fixing bracket by screwing it with screws.

Step 5

Take the cords and thread them through the rollers on the brackets. Please note that there are two cords on each crossbar, the short one should go directly to the mount on the wall, and the long one hooks onto the roller on the side opposite to the mount, then it is pulled parallel to the crossbar to the wall and goes down to the fixing bracket. Thus, the fixing bracket will have two ropes of the same length. Then thread them through the cap for a secure top fit. Pull the cords through the cap provided to secure the bottom position.

Step 6

Check if the dryer is installed correctly. Using the caps, the position of the crossbars should be easily adjusted. Wipe the rungs with a damp cloth, set them parallel to the floor and start using.

Recommended: