How To Repair A Blowtorch

Table of contents:

How To Repair A Blowtorch
How To Repair A Blowtorch

Video: How To Repair A Blowtorch

Video: How To Repair A Blowtorch
Video: BernzOmatic TS8000 Blowtorch Ignition Fix/Repair 2024, March
Anonim

The blowtorch is a portable directional flame torch used to heat parts. This device is widely used in everyday life, so there is a high probability that the lamp may break. You can even repair this device at home.

How to repair a blowtorch
How to repair a blowtorch

It is necessary

  • - screwdriver;
  • - needle;
  • - wire;
  • - oil for lubrication;
  • - pliers.

Instructions

Step 1

Every tool used in everyday life has its own "Achilles' heel". The most common blowtorch malfunctions include the failure of the pump, which builds up pressure in the tank with the "fuel", and clogging of the nozzle. Somewhat less often, you can encounter a malfunction of the shut-off valves.

Step 2

Examine the blowtorch carefully and identify the problem. If possible, find out the reason that led to this breakdown.

Step 3

If, after opening the valve, "fuel" oozes or bubbles, but does not flow properly, then the problem is rooted in the nozzle. Clean the calibrated hole with a needle. If there is no result, then this component of the portable burner will have to be cleaned a little differently.

Step 4

Unscrew the jet and try again to clean it. Then push a thin wire into the fuel pipe, open the valve and flush this channel with gasoline. After the above procedure, reinstall the jet and fix it.

Step 5

A malfunction of the blowtorch can be manifested in the fact that during the operation of the torch, you can hear hiss or other extraneous noises. The problem in this case is rooted in a malfunction of the pumping device.

Step 6

To eliminate a malfunction associated with the operation of the pumping device, unscrew the plug and pull the pump out. Remove the spool located on the pump valve, clean this element of the burner structure from contamination and replace its spring. Lubricate the cuffs on the stem with engine oil.

Step 7

If, during the operation of the blowtorch, a flame begins to burn from under the stem, extinguish the fire, and then remove the valve handle and plug and then change the stuffing box packing of the intake needle.

Recommended: